Reference Digital Audio 40 - Q. What is the minimum bending radius of this cable?
Answer:
The minimum bend radius is 25 mm. The characteristic impedance the cable depends entirely on the geometry and if this is distorted then a localised impedance mismatch will cause reflections and increased jitter in the digital signal; the cables will work better if they are routed as flat and straight as possible.
Related Articles
XT40i - Q. What is the minimum bending radius of this cable?
Answer: The XT40i is a large cable with a specific internal construction that is important to the way it sounds. In order to not crush the hollow X-Tube filler rods, a minimum bend radius of 30mm is required, however the cables will work better if ...
Reference Digital Audio 40 - Q. What is special about the QED Reference Digital Audio 40 plugs?
Answer: The Reference Digital Audio 40 is made using a cable with a very tight 75 ohm characteristic impedance, however the standard RCA plugs (which have to be used because the domestic S/PDIF connector uses them), are not designed to be 75 ohm. ...
Audio 40 - Q. Is the QED Audio 40 cable directional?
Answer: No, the Audio 40 range are not directional. This is because the cable is wired in traditional unbalanced mode, similarly to a co-axial cable, using the braid as both a shield and a path for return currents. This gives the cable exceptionally ...
Q. Are digital coax cables capable of hi res audio?
Answer: Ordinary 75 ohm coaxial cable has been used for years as TV aerial cable with frequencies in the UHF band 470 MHz and beyond so 24/384 at 18 Mb/s would be no problem for a cable like this. However with digital coaxial outputs, like all such ...
Audio 40 - Q. Why are the conductors so small in your QED Audio 40 range?
Answer: QED Audio 40 cables are designed primarily to have low capacitance, we have found that these sound the best for various technical reasons. The larger the conductors the more difficult it is to keep the capacitance low so, we have used the ...